Jacuzzi J-13 - 7 Power Requirements; 8 Swim Spa Fill up Procedure

18
7.0 Power Requirements
Jacuzzi® swim spas are designed to provide opmum performance and flexibility of use when
connected to their maximum electrical service. They are configured at the factory. The most
common electrical connecons are listed below.
NORTH AMERICAN
MODELS (60 Hz)
EUROPEAN
MODELS (50 Hz)
VOLTAGE 240VAC 230VAC
Frequency (Hz) 60 50
Number of wires 4 3
RATINGS GFCI RCD
PowerPlay™ Series 50 40
PowerAcve™ Series 50 40
PowerPro® Series 60 40
8.0 Swim Spa Fill Up Procedure
For best results, read each step in its enrety before proceeding with this procedure. Make
sure that all drains and drain plugs are closed.
1. Prepare the Swim Spa for Filling
 Clear all debris from the swim spa (Although the swim spa shell has been polished
at the factory, you may want to treat it with a specially formulated spa cleaner.)
Consult your authorized Jacuzzi® dealer for addional informaon prior to filling.
 Remove both filters, skimmer, polishing filter lids and filters.
2. Fill Swim Spa
 Place the end of your garden hose into empty skimming filter fing as you stand
next to the swim spa. Fill swim spa half way, then place the garden hose into the
opposite filter fing while adding the remaining fill water.
CAUTION: TO DECREASE BUILD UP ON COMPONENTS AND MINIMIZE ACRYLIC DAMAGE.
Never fill with water from a water soener. If your water is extremely “hard”, it is
preferable to fill half-way with hard water and the rest of the way with soened
water. Water that is too so can be corrosive to metal components.