Jacuzzi J-13 - Page 19

19
WARNING: TO DECREASE RISK OF INFECTION AND DISEASE.
Fill the swim spa with clean tap water from garden hose, to reduce the risk of
contracng a waterborne illness (e.g. an infecon, bacteria or virus) and/or respiratory
ailments. Fill unl water covers all the jets but does not touch the boom of the lowest
headrest (DO NOT OVERFILL!).
IMPORTANT: Always fill your swim spa through both filter fings aer draining. Failure to
do so may cause air to be trapped in the pumps, prevenng the pumps from circulang water.
Remove the hose and replace both filter cartridges as illustrated in Secon 13.1.
3. Turn On Power
Turn on the power to the swim spa at the home’s circuit breaker. The heater and filter/
circulaon pump will automacally acvate. Normally, at the inial fill, the water tends
to be cold.
4. Acvate Jet Pumps
Turn on jet pumps when adding chemicals in step 5 (see secon 11.2)
5. Add Start-Up Chemicals
Add the swim spa water chemicals as recommended by your authorized Jacuzzi® swim
spa dealer. See secon tled “Water Quality Maintenance” for general guidance.
WARNING: RISK OF POISONING OR DEATH.
Never leave chemicals opened and accessible to anyone. Use chemicals according to
the vendor’s instrucons. Always store chemicals in a safe and/or locked locaon. Keep away
from and out of reach of children.
6. Establish a Stable Sanizer Reading
Establish a stable sanizer reading of no less than 2.0 ppm free bromine or no less than
1.0 ppm free chlorine. To ensure healthy water condions, always maintain a constant
sanizer reading within the levels recommended on the inside cover of this manual. If
sanizer levels cannot be stabilized, perform the decontaminaon procedure steps 9-15
on the following pages.
Note: The “Decontaminaon Procedure” should also be used aer the swim spa has been
“Winterized” (Secon 13.8) or has been sing without power for an extended period.