Jacuzzi J-13 - Page 20

20
7. Set Swim Spa to Heat
To warm swim spa water to a comfortable temperature, follow these steps:
 The display on the control panel displays the actual temperature of the swim spa
water. Tap the “+” or “-” to increase or decrease the water temperature in 1 degree
increments.
 The heater will turn off 1
o
F (0.5
o
C) above the set temperature and turn on 2
o
F (1
o
C)
below set temperature.
Note: The temperature range for the swim spa is 80 to 104
o
F (27 to 40
o
C). To acvate the
Extended Temperature feature that allows the swim spa to reach 106
o
F (41
o
C) refer to
Secon 15 “Error/Display Messages”.
Important Heater Details:
 The maximum temperature for which the swim spa can be set is 104
o
F (40
o
C) and the
minimum is 80
o
F (27
o
C).
 Seng the thermostat at maximum will not accelerate the heang process. This will only
result in a higher ulmate temperature.
 The heater operates unl the water reaches 1
o
F (0.5
o
C) degree above the programmed
“set temperature”, then turns off. The heater will reacvate aer the water cools to
approximately 2
o
F (1
o
C) below the “set temperature”.
8. Place Cover on Swim Spa
 Keeping the insulang cover in place anyme the swim spa is not in use will reduce
the me required for heang, thereby minimizing operang costs.
 The me required for inial heat-up will vary depending on the starng
temperature.
DANGER: RISK OF PERSONAL INJURY.
Check water temperature carefully before entering swim spa! Excessive water temperature
can cause burns, welts and body temperature to rise, hyperthermia (over-heang).