J ADEVER SCALE CO., LTD
JWI-700W 5
CONN
1
2
3
4
5
E+
E-
S+
S-
LOAD-CELL
Shield
4. Installation
4-1 LoadCell connection
PIN SIGNAL
1 E+
2 E-
3 S+
4 S-
LOAD CELL
CONNECTION
5 SHIELD
4-2 Assembly Description of Upright Pole
(1) Rod seat
(2) Upright pole
(3) Bracket
(4) Indicator
(5) Screw (for fixing the upright pole)
(6) Screw (for fixing the Bracket)
(7) Knob pole
(8) Bracket slot
(9) Load cell wire
Step 1: Thread the wire of the Load Cell (9)on the
Rod seat (1) through the upright pole (2), insert
The upright pole into the rod seat and then
Lock it with two screws (5).
Step 2: After threading the Load Cell wire
Through the bracket (3), attach the bracket to the
Upright pole and then lock it with the screw (6).
To Next Page
Loading...
Need help?
General
