janitza Prophi User Manual

Page 54
Reactive Power Controller
= Key 1 = Key 2 = Key 3
Technical data
Weight : 1kg
Combustion value :ca. 700J (190Wh)
Ambient conditions
Overvoltage class : III
Pollution degree : 2
Operating temperature : -10°C .. +55°C
Storing temperature : -20°C .. +60°C
Spurious radiation (residential areas):
DIN EN61326-1:2006, class B
IEC61326-1:2005
Sensibility to disturb. (industrial areas) :
DIN EN61326-1:2006, class A
IEC61326-1:2005
Sensibility to disturb. (industrial areas) :
DIN EN61326-1:2006, table 2
IEC61326-1:2005
Safety guidelines :EN61010-1 08.2002
IEC61010-1:2001
Mounting position : any
Operating height : 0 .. 2000m over NN
Humidity class : 15% to 95% without dew
Protection class : I =Device with protective wire
Protection class
Front : IP65 according to IEC60529
Back : IP20 according to IEC60529
Inputs and outputs
Tariff changeover
Current consumption : about 2,5mA .. 10mA
Switching outputs
Testvoltage against ground : 2200V AC
Relay outputs
Switching voltage : max. 250VAC
Switching power : max. 1000W
Max. switching frequency : 0,25Hz
Mechanical life expectancy : >30x10
6
switchings
Electrical life expectancy : >7x10
6
switchings
(Load = 200VA, cosphi=0,4)
transistor outputs
Switching voltage : 15 .. 30VDC
Switching current : max. 50mA
Max. switching frequency : 10Hz
Measurement
Measurement and supply voltage U: see type plate
Range for U : +10% , -15%
Prefuse : 2A .. 10 A
Power consumption : max. 7VA
Rated pulse voltage : 4kV
Tested voltage against ground : 2200V AC
Frequency of fundamental : 45Hz .. 65Hz
Current measurement
Signal frequency : 45Hz .. 1200Hz
Power consumption : about 0,2 VA
Rated current at../5A (/1A) : 5A (1A)
Minimum working current : 10mA
Maximum current : 5,3A (sinus shape)
Overload : 180A for 2 Sec.
Measuring rate : 30(50) Measurement/Sec.
Actualization of indication : 1 / second
Zero voltage release : < 15ms
Measurement accuracy
Voltage : +- 0,5% omr
Current : +- 0,5% omr
cos(phi) : +- 1,0% omv
1)2)
Power : +- 1,0% omr
Frequency : +- 0,5% omv
2)
Those specifications presuppose a yearly calibration and a preheating
of 10 minutes.
omr = of measuring range
omv = of measured value
1)
Valid for current inputs >0.2A and in cos(phi) range 0,85 up to 1,00.
2)
In the range of -10..18°C and 28..55°C an additional inaccuracy of +-0,2‰ of measured value per K must be respected.
3)
Devices with option "RS485 interface" are only suitable for an ambient temperature of -10°C .. +50°C.

janitza Prophi Specifications

General

Brand	janitza
Model	Prophi
Category	Controller
Language	English