55
UMG 512
Configuration
The supply voltage must be connected for
the configuration of the UMG 512.
Connecting the supply voltage
• The supply voltage level for the UMG 512 is specified
on the rating plate.
• After applying the supply voltage, a start-up display
appears. Approximately ten seconds later, the UMG
512 switches to the first "Home" measured value
display.
• If no display appears, check whether the applied
supply voltage is within the rated voltage range.
Please note!
If the supply voltage does not correspond
to the voltage indicated on the rating
plate, this may lead to malfunctions and
severe damage to the device.
c
Fig. Example of the "Home" measured value
display
To Next Page
Loading...
