Janome 1110DX - The Position of Thread Guide Bar; Attaching the Spool Holder Cap and Net

16
Pull the thread guide bar up as far as it will go.
The Position of Thread Guide Bar
1 Thread guide bar
2 Thread guide
Attaching the Spool Holder Cap and Net
1. When you use a small thread spool, pull out the
spool holder from the spool pin. Then place the spool
with its slit side up, and put the spool holder cap on top
of it.
2. If the thread slips down from the spool during
threading and/or sewing, put a net on the spool as
illustrated to prevent jamming.
1 Net
2 Spool pin
1 Spool holder
2 Spool pin
3 Spool holder cap
4 Slit
1
2
2
1
1
3
4
2
1
2