Janome 1110DX - PIN TUCKING; Thread and Fabric; Machine Setting; Sewing

84
PIN TUCKING
*
Refer to page 74 (Narrow Hemming) for thread
tension balance adjustment.
1 Pin tucking
Thread and Fabric
Fabric
Light to
Medium
Fabric
Needle thread on the
right
Upper looper thread
Lower looper thread
Synthetic : No. 60~80
Silk : No. 50~80
Synthetic : No. 60~100
Silk : No. 50~100
Thread
Machine Setting
1 Remove the needle on the left-hand side
2 Upper knife : Down
3Lower looper pre-tension setting slider : STD
4 Changeable thread guide : 3/4
Sewing
Tu rn off the power switch.
Remove the needle on the left-hand side.
Deactivate the upper knife.
Tu rn on the power switch, then sew the folded edge while
guiding along the guide line.
1Folded edge
2 Guide line on the needle plate
3 Right needle position line on the presser foot
4 Left needle position line on the presser foot
5 Right side of fabric
Open the fold flat and press the pin tucks to one side.
NOTE: After you finish sewing,return the upper knife
to rhe original position.
6 Pin tucking
2
1
1
3
4
5
6
1
w
r
e
2