EasyManua.ls Logo

Janome 1110DX - Needle;Lower looper thread tension is out of balance (2); Correct tension for rolled hem

Janome 1110DX
99 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
70
Needle/Lower looper thread tension is out of
balance (2)
The illustration shows sewing results when the needle
thread tension is too tight and/or lower looper thread
tension is too loose.
Remedy:
Loosen needle thread tension and/or tighten lower looper
thread tension.
o Left needle thread tension dial
!0 Right needle thread tension dial
!1 Lower looper thread tension dial
Correct tension for rolled hem
* The illustration shows sewing result with correct tension
settings.
Set the changeable thread guide at the lowered position.
Other settings are same as the 3-threads rolled hem (See
page 76).
However, tension adjustment may be required depending
on the type and thickness of fabric and threads being
used.
Make a trial sewing with the fabric and threads you wish to
use to obtain in the best results by adjusting tension.
q Wrong side of fabric
w Right side of fabric
e Needle thread
r Lower looper thread
q
w
e
r
q
w
e
r
o
!0
!1

Table of Contents

Other manuals for Janome 1110DX

Related product manuals