Janome 1600P - Knee Lifter Lever

10
13. Knee Lifter Lever
The presser foot rises 7.5 mm when it is fully raised with
the knee lifter.
[1] Remove the base and lay the machine on its back.
[2] Loosen the nut (1) on the knee lifter lever (2) slightly
and turn the adjusting screw (3) to adjust the height.
- If it is lower than 7.5 mm, turn the adjusting screw
(3) clockwise.
- If it is higher than 7.5 mm, turn the adjusting screw
(3) counterclockwise.
(Use the 5th step from the left of the Gauge 767G-001
for 7.5 mm).
[3] Tighten the nut (1) firmly and attach the base.
NOTE:
Lower the needle bar to the lowest position and check if
the needle clamp does not hit against the presser foot
when it is fully raised.
7.5 mm
(1)
(2)
(3)
7.5 mm