18
6. Driving Motor (continued)
To attach:
[1] Install the driving motor (1) to the motor bracket (2)
and attach the motor belt (3). Tighten the nuts (4)
firmly.
[2] Loosen the setscrews (5) slightly and move the motor
up or down to adjust the motor belt tension.
The belt should deflect 4 - 5 mm when applying 300
grams of load to the middle of the belt.
Tighten the setscrews (5) firmly.
[3] Insert the motor connector (6) and motor sensor
connector (7).
[4] Attach the motor cover and belt cover.
(1)
(2)
(3)
(5)
(4)
(6)
Motor belt tension
4 - 5 mm
(7)
To Next Page
Loading...
