19
Button Sewing
Machine setting
q Stitch selector: B – C
w Stitch length: Any
e Needle thread tension: 3 – 7
r Presser foot: Zigzag foot A
t Feed dog: Dropped
1. Drop the feed dogs. Place the button below the zigzag
foot, making sure to align the holes with the horizontal
slot in the foot. Lower the presser foot to hold the
button in place.
2. Determine which stitch width setting matches the
distance between the button holes. The needle must
go safely through each hole when sewing.
Unthread the needle to help you determine the zigzag
width.
3. Thread the needle. Turn the handwheel, so that the
needle is in its leftmost position, and then drop the
needle through the left buttonhole.
4. Press the foot control and sew about 10 stitches.
5. Sew the other row of holes (if applicable) using the
steps above. Trim excess threads from both sides of
the fabric.
This is similar to a very short satin stitch and is used to
reinforce points of strain such as corners, pockets and
straps of lingerie.
Sew four (4) to six (6) stitches.
Bar Tacking
Machine setting
q Stitch selector: B – C
w Stitch length: 0.5 – 1
e Needle thread tension: 1 – 4
r Presser foot: Zigzag foot: A
we
r
q
t
we
r
q
Janome 5812 Instruction Manual
5812 Owners Manual/ User Guide
To Next Page
Loading...
