Janome 5812 - Threading the Machine; Drawing up the bobbin thread

www.toews.com
11
Threading the Machine
* Raise the thread take-up lever to its highest position by
turning the handwheel counterclockwise.
* Raise the presser foot lifter.
* Place a spool on the spool pin, with the thread coming
off the back of spool (refer to page 18).
z Draw the end of the thread around the upper thread
guide.
x While holding the thread near the spool, draw the end of
the thread down around the check spring holder.
c Firmly draw the thread up from right to left over the
take-up lever, and down into the take-up lever eye.
v Slide the thread behind the needle bar thread guide on
the left.
b Thread the needle from front to back, or use a needle
threader.
Drawing up the bobbin thread
z Raise the presser foot and hold the needle thread
lightly with your left hand.
q Needle thread
x Turn the handwheel slowly toward you one complete
turn. Bring the bobbin thread up by pulling the needle
thread as illustrated.
q Needle thread
w Bobbin thread
c Pull 4˝ (10 cm) of both threads back and under the
presser foot.
5
4
3
1 2
q
z
c
x
w
q
z
c
x
v
b
q
w
Janome 5812 Instruction Manual
www.toews.com
5812 Owners Manual/ User Guide