Janome 6019QC - Inserting the bobbin

10
1
2
3
4
1
2
3
5
4
•
Inserting the bobbin
Remove the hook cover and place the bobbin in
the bobbin holder with the thread running
counter-clockwise.
Guide the thread into the notch A on the front side
of the bobbin holder. Draw the thread to the left
sliding it between the tension spring blades.
Notch A
Continue to draw the thread lightly until it slips into
notch B.
Notch B
Pull out about 10 cm (4˝) of thread and attach the
hook cover.
Bobbin thread
Hook cover plate
Threading diagram
1
2
3
4
1
2
3
4
5