Janome 6019QC - Adjusting Stretch Stitch Balance

36
(A)
(B)
Adjusting Stretch Stitch Balance
The sewing results of the stretch stitch patterns may
vary depending upon the sewing conditions, such as
sewing speed, type of the fabric, number of layers etc.
Always make test sewing on a scrap piece of the
fabric that you wish to use.
(A) If the pattern is compressed, turn the stretch stitch
balancing dial in the direction of “ + ”.
(B) If the pattern is drawn out, turn the stretch stitch
balancing dial in the direction of “ – ”.
NOTE: In normal sewing, set the dial to the neutral
position, i.e. the groove on the dial is centered
with the standard setting mark.
Stretch stitch balancing dial
Standard setting mark
Groove
Correct shape
1
2
3
4
1
2
3
4
CARE OF YOUR MACHINE
Replacing the Light Bulb
WARNINGS:
Turn off the power before replacing the light bulb.
The bulb could be HOT, wait until it has cooled down
before touching it.
(A)
•
To remove .......... Turn to the left.
•
To replace .......... Tuen to the right.
(B)
•
To remove .......... Push and twist to the left.
•
To replace .......... Push and twist to the right.
Cap
Setscrew
Face plate
Lamp Socket
Light bulb
1
2
3
(A)
(B)
1
2
3
4
5
5