Janome 6019QC - Pattern Selector Dial; Stitch Width Lever; Variable Needle Drop Position

14
Pattern Selector Dial
Turn the pattern selector dial to select the desired
pattern. The selected pattern will be shown in the
pattern indicating window.
NOTE: Raise the needle above the fabric when
turning the pattern selector dial.
Pattern selector dial
Pattern indicating window
Stitch Width Lever
Slide the stitch width lever to set the setting mark at
the desired stitch width.
The higher the number, the wider the stitch width.
Stitch Width Lever
Setting mark
NOTE: Raise the needle above the fabric when
sliding the stitch width lever.
Variable Needle Drop Position
When one of the straight stitches (patterns #2, 23 and
24) is selected, you can move the needle between
center and left needle positions.
Hole on the needle plate
2
1
2
1
3
3
1
2
1
2
3