16
Threading the Machine
Raise the presser foot. Press the needle up/down button
to raise the thread take-up lever to its highest position.
CAUTION:
Turn off the power switch before threading the machine.
z Turn the power switch off. Draw the thread around the
upper thread guide.
q Upper thread guide
x While holding the thread near the spool, draw the
thread down along the right channel.
w Right channel
c Pull the thread up around the bottom of the thread
guide plate.
Pull the thread up along the left channel.
e Thread guide plate
r Left channel
v Firmly draw the thread up and to the back of the
take-up lever. Draw the thread forward to pass it into
the take-up lever eye.
t Take-up lever eye
b Pull the thread down along the left channel and pass
the thread through the lower thread guide.
y Lower thread guide
n Slide the thread behind the needle bar thread guide
on the left.
u Needle bar thread guide
m Thread the needle from front to back, or use the
needle threader.
i Needle
q
w
e
t
y
u
i
z
x
c
v
b
n
m
z
x
c
v
b
n
m
r
To Next Page
Loading...
