Janome DC6030 - Fagoting; Scallop Stitch

43
Scallop Stitch
q Stitch pattern: 18, 22
w Thread tension dial: 3 to 6
e Presser foot: Zigzag foot A
Sew the stitches approximately 1 cm (3/8˝) inside the
fabric edge.
Trim the outside of the stitches as shown. Make sure
not to cut the thread.
Fagoting
q Stitch pattern: 11, 17, 20
w Thread tension dial: 3 to 6
e Presser foot: Satin stitch foot F
Use these stitches to join two pieces of fabric to create
an open work appearance and add design interest.
Fold under each fabric edge 1.5 cm (5/8˝) and press.
Pin the two edges to paper or tear backing 0.3–0.4 cm
(1/8˝) apart.
Sew slowly, guiding the fabric so the needle catches the
folded edge on each side.
After sewing is finished, tear away the paper.
q 0.3–0.4 cm (1/8”)
w Paper
4
q
w
e
4
q
w
e
q
w