Janome DC6030 - Multiple Zigzag Stitch; Overedge Stitch; Double Overedge Stitch

26
4
4
4
Overedge stitch
q Stitch pattern: 09
w Thread tension dial: 3 to 7
e Presser foot: Overedge foot C
This stitch is used to seam and overcast fabric edges at
one time.
Use this stitch when you do not need to open seams flat.
Sew while guiding the fabric edges along the guide on
the foot.
r Guide
NOTE:
The stitch width cannot be adjusted to less than 4.5 to
prevent the needle from hitting the wires on the foot.
Double overedge stitch
q Stitch pattern: 10
w Thread tension dial: 3 to 7
e Presser foot: Overedge foot C
This stitch is excellent for sewing fabrics that tend to fray
extensively such as linens and gabardines.
Two rows of zigzag stitches are simultaneously sewn
over the edge to insure that your seams will not ravel.
Sew while guiding the fabric edges along the guide on
the foot.
r Guide
NOTE:
The stitch width cannot be adjusted to less than 4.5 to
prevent the needle from hitting the wires on the foot.
qw
e
qw
e
qw
e
Multiple zigzag stitch
q Stitch pattern: 08
w Thread tension dial: 3 to 7
e Presser foot: Zigzag foot A
This stitch is used to finish a raw edge of synthetics and
other stretch fabrics that tend to pucker.
Sew along the fabric edge leaving an adequate seam
allowance.
After sewing, trim off the seam allowance closer to the
stitches.
This stitch is also excellent for darning and mending
tears.
r
r