Janome DC6030 - Selecting the Patterns; Sewing

47
Selecting the patterns
Select the desired pattern suitable for twin needle
sewing.
Press the twin needle button.
q Twin needle button
The LCD screen shows a twin needle icon and the
maximum permissible stitch width is restricted to 3.0
mm.
The needle drop position of straight stitches is restricted
to between 2.0 and 5.0.
w Twin needle icon
e Maximum width (3.0)
NOTES:
If you press the twin needle button, a warning signal
sounds and the twin needle icon blinks when a pattern
not suitable for twin needle sewing is selected.
After pressing the twin needle button, patterns not
suitable for twin needle sewing cannot be selected.
If you press the twin needle button again, the LCD
screen shows only the blinking twin needle icon and all
the buttons except for the twin needle button will be
deactivated. Press the twin needle button again to
change the setting to single needle sewing.
Sewing
Sew at a medium speed.
When changing the sewing direction, raise the needle
from the fabric.
NOTE:
Use the thread cutter on the face plate when sewing with
the twin needle.
q
w
e