Janome Memory Craft 3000 - To Adjust the Feed Dog Height

To adjust the feed dog height
When pressure adjusting lever (C) is at “3” and the presser foot (D) is lowered, the highest
position of the feed dog (E) should be 0.80 to 0.90 mm (H) from the surface of the needle plate
(F).
1. Set the pressure adjusting lever (C) at “3” with the presser foot lowered.
2. Turn on the power switch.
3. Turn the balance wheel toward you to get the highest position of feed dog.
4. Remove the bed cover.
5. Loosen the set screw (A) and nut (G).
6. Adjust the feed dog height to 0.80 mm to 0.90 mm by turning the adjusting screw (B).
7. Tighten the nut and set screw (A).
8. Attach the bed cover.
11