Board C and fuse attaching and removing
(TO REMOVE)
1. Remove the rear cover.
2. Remove 3 screws (A) and Board C (See page 18).
3. Remove 3 screws (B) and remove case cover (G).
4. Replace fuse or Board C.
(TO ATTACH)
5. Attach the case cover with 3 screws (B).
6. Attach the Board C with 3 screws (A).
7. Attach the rear cover.
NOTE: To replace fuse, pry it out of the fuse holder (D) with a screwdriver as shown below.
The following two specified fuses are used for Board C:
E: 250V, 2.0A
F: 250V, 5.0A
19
To Next Page
Loading...
