Page 22
Quilt Maker Pro 18 User Manual
201704
Basting Stitches
There are four basting stitch settings controlled by
the stitches per inch function. After the SPI reaches its
lowest stitch setting of 4 stitches per inch, pressing the
“-” button will activate the basting settings:
• 0.5-inch (one stitch every half-inch movement of
the machine)
• 1-inch (one stitch every one inch movement of the
machine)
• 2-inch (one stitch every two inches of movement of
the machine)
• 4-inch (one stitch every four inches of movement
of the machine)
After selecting the basting stitch setting, begin quilting
by pressing the Start button. As you move the machine
across the quilt, it will perform a stitch (needle down and
then needle up) every half inch, one inch, two inches, or
four inches according to your choice. The basting stitch
options are available in stitch regulation mode: Cruise
and Precision. (Figure 30)
Stitch Regulation Style (SR)
The “SR Style” box in the lower right-hand corner of the
screen indicates whether the machine is in “Precision”
regulation mode or in “Cruise” regulation mode. (Figure
30)
Precision
If “Precision” mode is selected, the Janome
Quilt Maker
Pro 18 will not start stitching until you begin pushing the
machine. (Figure 31)
Figure 30
Figure 31
To Next Page
Loading...
