janome.com
Page 41
Important Information
Regulatory Information
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant
to part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful
interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy
and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that
interference will not occur in a particular installation.
If this equipment does cause harmful interference to
radio or television reception, which can be determined
by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or
more of the following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and
Receiver.
— Connect the equipment into an outlet on a circuit
different from that to which the Receiver is
connected.
— Consult the dealer or an experienced radio/TV
technician for help.
This Class B digital apparatus complies with Part 15 of
the U.S. Federal Communications Commission (FCC)
rules, Canadian ICES-003 and RSS-210. Operation is
subject to the following two conditions: (1) this device
may not cause interference, and (2) this device must
accept any interference received, including interference
that may cause undesired operation.
Réglementations
Cet appareil numérique de la classe B est conforme
aux norms NMB-003 et CNR-210 du Canada. Son
fonctionnement est assujetti aux deux conditions
suivantes: (1) Cet appareil ne puet pas provoquer
d’interférences nuisibiles et (2) cet appareil doit accepter
toute interference recue, y compris les interferences
pouvant entraîner un fonctionnement non desire.
Specifications
Bobbin Winder
Input Power - 12Vdc at 2.5 A maximum
Variable speed winding
3600 rpm maximum winding speed
Auto-shut off sensor
Auto-shut off after 5 minutes
Bobbin winder power supply
Input: 100 – 240VAC 50/60Hz 50VA
Output: 12Vdc at 3A
To Next Page
Loading...
