Janome QUILT MAKER PRO - General Specifications

janome.com
Page 5
To use the machine safely
1. Carefully watch the needle when sewing. Do not
touch the hand wheel, take up lever, needle, or other
moving parts.
2. Turn the machine off and unplug the cord in the
following cases:
• when you have stopped using the machine
• when you replace or remove the needle or any
other part
• when you check or clean the machine
• when you leave the machine unattended
3. Connect the machine directly to the wall outlet or to
a surge protector that connects directly to the wall
outlet. Do not use extension cords.
To increase the life of your machine
1. Do not store this machine in areas exposed to direct
sunlight or high humidity. Never use or store the
machine near a heater, an iron, a halogen lamp or
other hot things.
2. Use only neutral soaps or detergents to clean the
machine. Benzene, solvents and scouring powders
can damage the case and the machine and therefore
should never be used.
3. Do not drop or bump the machine.
4. Always consult the manual to replace or fix the
hopping foot, needle or any other part of the
machine. If necessary contact an authorized Janome
representative or Janome technical support.
General Specifications
The Janome Quilt Maker Pro 18 utilizes high-tech
electronics and an innovative touch-pad user interface
to offer greater functionality and ease of operation to
home quilters than ever before conceived in the quilting
industry. The Janome
Quilt Maker Pro 18 quilting machine
is a high quality machine that incorporates very robust
design features and is very easy to service.
Disclaimer
Janome and its Representatives are in no way legally
responsible or liable for damage to the Janome
Quilt Maker Pro 18 when used improperly or not in
accordance with the guidelines stated in this manual
or when used on Machine Quilting Frames not
recommended by Janome.
Sewing Opening Dimensions:
Sewing Speed:
Stitches-Per-Inch:
Needle System:
Needle Sizes (recommended):
Hook System:
Bobbin Type:
Bobbin Case:
Motor Type:
Needle Positioning:
Electrical Power:
LED Power Consumption:
Sew Foot Stroke/Lift:
Needle Bar Stroke:
Take-Up Stroke:
Lubrication, main components:
Lubrication of hook:
(245 mm X 610 mm) 8.25” X
18”
Manual Mode:
Min 90spm, Max 2,200spm
Regulated Mode:
Min 0spm, Max full speed
4spi – 22spi
134 (135 X 7)
12/80 - 20/125
Rotary, Horizontal axis, M-class
bobbin
Aluminum, Class M
Type MF
Brushless DC
Up and down, walking stitch
100 – 240 VAC, 50 - 60Hz,
300W peak
(1.69A@100/.9A@240)
8 W
5 mm
35.3 mm
73 mm
Kluber Lube, permanent
Velocite 10, Texaco 22