Page 30
Quilt Maker Pro 18 User Manual
201704
Calibrate Tension
The Tension button enables you to calibrate the tension
device (Figure 51). You should only calibrate the tension
device under the direction of Janome technical support.
While calibrating the tension, you will be asked to do the
following:
1. Remove the tension knob.
2. Gently press the spring against the tension discs while
not compressing the spring.
3. While holding the spring in place, press Reset.
4. When calibration is complete, replace the tension
knob.
Figure 51
To Next Page
Loading...
