UD - 319472K - 81 -FRENDE
The transmit radio frequency and the "dead man" function duration are saved into the electronic
key. Procedure below enables authorization (electronic key unlocked) or prohibition (electronic
key locked) of any modification of these 2 parameters.
1- Switch off the UDR receiver.
2- Insert the electronic key in the UDE transmitter unit.
3- Holding buttons n°1, n°2 and n°3 * pressed, unlock the stop palmswitch button (fig.1).
4- Release the buttons.
Indicator lights statuses:
- electronic key locked : red indicator light on, green indicator light off.
- electronic key unlocked : red and green indicator lights on.
5- Select «locked» or «unlocked» by pressing button n°2; the selected mode is shown by the
indicator lights (fig.2&3).
6- Validate the selected mode by pressing the "On/Horn" button (fig.4).
7- The UDE transmitter saves the new mode in the electronic key and switches off the indicator
lights.
8- Exit the "locking - unlocking" configuration mode by pressing the stop palmswitch button (fig.6).
Remark: If an operator attempts to program the frequency or the "dead man" function duration
with the electronic key locked, the UDE transmitter will indicate an error by its indicator
lights (red and green) which will flash in alternation.
3.5.1 Procedure: "Locking-unlocking" the electronic key
(access to programming of transmitter UDE)
* = If the button n°3 is not BPSV or BPDV type, use then the green «On/Horn» button.
Fig.1
Fig.2
Fig.4 Fig.5 Fig.6
Fig.3
Locking
the
electronic
key
Unlocking
the
electronic
key
To Next Page
Loading...
Need help?
General
