Jay electronique UC Series User Manual

- 84 - UD - 319472KFR EN DE
* = If the button n°3 is not BPSV or BPDV type, use then the green «On/Horn» button.
1- Switch off the UDR receiver
2- Insert the electronic key in the UDE transmitter unit.
3- While holding buttons n°2 and n°3 * pressed, unlock the transmitter emergency stop button
(fig. 1): the 2 indicator lights on the transmitter will flash rapidly.
4- Press the "On/Horn" button to perform automatic programming of the identity code: the two
indicator lights on the transmitter go off (fig. 2).
5- The "identity code" information is copied from the electronic key to the transmitter memory (fig.
3).
6- Exit the programming mode by pressing the stop palmswitch button (fig.4).
Reminder :
To use the UD radio remote control system, the identity code contained in the transmitter memory
must match the identity code in the electronic key which is itself identical to that of the receiver.
If a maintenance transmitter is used or if you change electronic key, the information contained in the
electronic key must be copied in the UDE transmitter memory.
Conditions for using this procedure :
The configuration of the backup transmitter buttons must be identical to that described in the
electronic key (or the original transmitter).
DATA
3.5.4 Procedure: "Copying electronic key identity code to UDE transmitter
memory"
Apply this procedure when :
- starting the radio remote control for the first time
- using a maintenance transmitter
- changing the electronic key
Fig.3
Fig.1
Fig.2 Fig.4
electronic key
memory
UDE
transmitter
memory

Jay electronique UC Series Specifications

General

Brand	Jay electronique
Model	UC Series
Category	Remote Control
Language	English