Section 6 Page
6. Options
ALPHAM4/V1 SEPT 2011
1
6.1 Separator
How to select the separator ?
Go into starting position, tool in high position
OR
Press on the «CHANGEOVER OF TOOL» button on the keyboard
- Take a BTR key n°2
- Open the upper cover
-
Unscrew the support of separator stop located in front of the feeder at pick-up level,
in front of the beak
To select the separator (for mixed papers or cards) :
Move the support to the left
To use only the beak (for standard paper only) :
Move the support to the right
NOTICE : if you experience troubles with sensitive paper or hard paper, you
can reduce the speed by selecting the mode Card «70C» (see section 5 page
3)
To Next Page
Loading...
