Section 1 Page
1. Installation
ALPHAM4/V1 SEPT 2011
1
Important Precautions for Installation
1.1 Keep your machine away from the radiators and other sources of heat. The ambient
temperature has to be lower than 24°. Do not block the ventilation openings.
1.2 Do not place the machine against a wall : allow 0.5m minimum all around the machine
to facilitate tool changing.
1.3 Avoid locating the machine near other machines likely to transmit electro-magnetic
interference (for instance : welding outfit, radio, compressors, portable phones…).
1.4 Before switching the machine ON, read the operating instructions and before first time
use, read the precautions to be taken.
1.5 Power Supply : The machine needs to be connected to a 100-120 V (us) supply with
earth (imperative) to secure the electrical safety (Protection : circuit-breaker 16 A
curve C).
NOTE : Avoid neutral load on the installation, this is equipped with electronics generating
leakage current which can activate upstream protections.
To Next Page
Loading...
