JDS Uniphase MAP EDFA OAB 1550 - Laser Specifications; Before Initializing and Operating the Unit

2
AC – Alternating current
DC – Direct current
Fuse
On
Off
V
Volts
VA
Volt amperes
WARNING
The procedure can result in serious injury or loss of life if not carried out
in proper compliance with all safety instructions. Ensure that all
conditions necessary for safe handling and operation are met before
proceeding.
Laser Specifications
Laser specifications are outlined in Table 2.
Table 2: Laser Specifications
Parameter Specification
Wavelength 1525-1575 nm
Class IEC Class 3B
1
Output power 150 mW (maximum)
1.Per standard IEC 60825-1 and FDA standard 21 CFR1040.10, except deviations per Laser Notice No.50, July
2001.
Before Initializing and Operating the Unit
; Inspect the unit for any signs of damage, and read the user’s manual thoroughly.
; Install the unit as specified in the Getting Started section.
; Ensure that the unit has been installed in a properly grounded MAP System