1
Safety Information
The following safety instructions must be observed whenever the unit is operated, serviced, or
repaired. Failure to comply with any of these instructions or with any precaution or warning
contained in the user’s manual is in direct violation of the standards of design, manufacture, and
intended use of the unit. JDS Uniphase assumes no liability for the customer’s failure to comply
with any of these safety requirements.
Safety Symbols
The following symbols and messages can be marked on the unit (Table 1). Observe all safety
instructions that are associated with a symbol.
Table 1: Safety Symbols
Symbol Description
Laser safety. See the user’s manual for instructions on handling and operating
the unit safely.
CAUTION
The procedure can result in serious damage to or destruction of the unit if not
carried out in compliance with all instructions for proper use. Ensure that all
conditions necessary for safe handling and operation are met before
proceeding.
Electrostatic discharge (ESD). See the user’s manual for instructions on
handling and operating the unit safely.
Protective conductor terminal for electrical grounding to the earth.
To Next Page
Loading...