JDS Uniphase MAP EDFA OAB 1550 User Manual

MAP EDFA CASSETTE
User’s Manual

JDS Uniphase MAP EDFA OAB 1550 Specifications

General

Input Power Range	-30 to +10 dBm
Operating Temperature	0 to +50 °C
Storage Temperature	-40 to +70 °C
Gain	25 dB
Noise Figure	5 dB
Output Power	17 dBm
Polarization Dependent Gain	0.5 dB

Summary

Getting Help

Global Sales and Customer Service

Contact information for sales and customer service.

Instrumentation Customer Support and Service

Contact details for technical support.

Glossary

Safety Information

Safety Symbols

Explains safety symbols and their meanings for safe operation.

Laser Specifications

Before Initializing and Operating the Unit

Pre-operation checks and thorough user manual review before use.

Operating the Unit

Safety Features and Compliance

Details safety features and compliance with relevant standards.

Laser Safety Labelling

Describes identification labels and laser classification requirements.

Safety Interlock and Remote Interlock

Introduction

Key Features

Lists the main capabilities and performance characteristics of the cassette.

Applications

Outlines the uses of the MAP EDFA Cassette in various network scenarios.

Specifications

Optical Specifications

Details guaranteed optical performance parameters for OAB C-band models.

Supplementary Specifications

Provides physical and environmental specifications for the unit.

Getting Started

Checking the Shipment

Steps to verify shipment contents and inspect for damage.

Installing the MAP EDFA Cassette

Procedure for safely installing the cassette into the MAP chassis.

Cleaning Optical Connectors

Cleaning Universal Connector Adapter (UCA) Bulkheads and Internal Optical Connector

Instructions for cleaning UCA and internal optical connectors.

Cleaning Jumper Connectors

Operating and Maintenance Instructions

Front Panel - Booster

Description of the front panel layout and its controls/indicators.

Operating the Amplifier

Steps for operating the amplifier, including warm-up and connection.

User Interface

Overview of local and remote control interfaces for the unit.

Controls and Communication

MAP EDFA Commands Overview

Introduction to SCPI command structure for remote operations.

EDFA Commands and Queries

Standard Address Parameters

Fetch Commands

How to Fetch the Output of the EDFA

Instructions for querying the optical output power of the device.

Input Commands

How to Enable or Disable the ALS Function on the EDFA

Procedure to enable/disable Automatic Laser Shutdown based on signal loss.

Query the State of ALS

How to Set the LOS Threshold on the EDFA

How to Query the LOS Threshold of the EDFA

Source Commands

How to Set the Laser Current on the Cassette

Steps to adjust the laser current percentage for the cassette.

How to Query the Laser Current on the Cassette

How to Set the Laser Status of the Cassette

How to Query the State of the Laser on the Cassette

Local Interface

Using the Controller Cassette Key Pad

Guide on using the keypad for controlling the EDFA module.

Monitors and Controls in Manual Mode

Device Status Information Table

Device Status Information Definitions

Definitions for various status indicators and their meanings.

Device Fault Monitor Table

Device Fault Monitor Definitions

Definitions for fault indicators and troubleshooting guidance.

Software Guide

Basic Settings Screen

Overview of the basic functions and interface of the software.

Basic Screen Functions

Settings Screen

Settings Screen Definitions

Advanced Settings Screen

Advanced Screen Definitions

Status Settings Screen

Status Screen Definitions

Info Screen

About Screen

Service

Storing and Shipping

Guidelines for storing and shipping the unit to maintain optimal reliability.

Claims and Repackaging

Procedure for handling claims and repackaging damaged or incomplete shipments.

Returning Shipments to JDS Uniphase

Process for returning units, including RMA procedures and packaging.