41
Table 12: Settings Screen Definitions
Function Description
Input Power
Power
Displays input power in dBm or µW
Loss Of Signal Limit
Displays the limit at which the unit will assign loss of signal
alarm. Using cb the user can adjust the threshold.
Auto Laser Shut Down
Enable
Allows the user to enable Automatic Laser Shut Down. This
will cause the unit to shut down when the input drops below
the threshold set in the Loss of Signal Limit field.
Band Type: C
Displays the band the amplifier is operating in.
Output Power
Power
Displays output power in dBm or µW
Source Mode
N/A
Backreflection Limit (dBm)
N/A
Backreflection Enable
N/A
Update Mode
Execute Single Update
Allows user to update fields
Continuous / Single
Allows user to set update mode to “Continuous” or run a
“Single” update
To Next Page
Loading...