21
11.6 Adjustment of half-nut guide
Loosen two nuts (1, Figure 36) on the right side of
the apron and adjust the set screws (2, Figure 36)
until both half nuts move freely without play. Tighten
both nuts.
11.7 Replacing the V-belt
Remove tension on the V-belt by pulling lever
toward front of the machine (Figure 37).
Remove belt from the pulley and replace with new
belt. Move lever toward motor to tension belt. Close
the cover.
Caution: To avoid breaking the belt, move the
tension lever towards the front of the machine
before starting (Figure 38).
Figure 36
Figure 37
Figure 37
Figure 38
To Next Page
Loading...
Need help?
General
