Operation Manual
INDEX-2
Adjusting Belt Tension 75
Changing PTO Oil 74
Changing the Power End Oil 73
Charge Pump 76
Installation 76
Removal 76
Checking Belt Tension 74
Checking Power End Oil Level 72
Alternate Oil Check Methods 72
Checking PTO Oil Level 73
Crankshaft 88
Installation 89
Removal 88
Crosshead and Connecting Rod Assembly 84
Assembly 85
Bushing Inspection 84
Crosshead Inspection 85
Disassembly 84
Installation 86
Removal 84
Crosshead Pony Rod Seals 77
Installation 78
Removal 77
Replacing the Belts 75
Rod Journal Bearings 80
Inspection 81
Installation 82
Removal 80
UNx Pump 86
Installation 87
Removal 86
T
TRAINING 95
Additional Training Opportunities 95
FS Solutions Training 95
New Start-up Training 95
Safety Training 95
TROUBLESHOOTING 93
W
WATERBLAST SAFETY 1
General Safety Precautions 4
Be prepared 5
Check Connections 4
Check Pressure Ratings 4
Freezing Conditions 5
Inspect Equipment 4
Performing Maintenance Or Repairs 5
Purge The System 5
Read Instructions 4
Rupture Discs 4
Slowly Increase pressure 5
Store Components Properly 5
Test The system 5
Tighten Connections 4
Use The minimum Pressure Required 5
Use Two Operators 4
Recognizing Safety Information 1
Understanding Signal Words 1
Trailer Safety
Avoid Unit Instability 6
Breakaway System 6
Check Brake System 6
Check Lighting 6
Safety Chains 6
Tires and Rims 6
Trailer Hitch 6
Understanding Safety Decals 2
Waterblast Safety Manual 1
WATER TANK AND FILTRATION 41
Water Quality Requirements 41
Water Tank With Filters
Filter Cartridge Replacement 43
Filter Inspection 42
Secondary Filter (40K Operation Only) 42
Switch Adjustment 43
Uni-Valve Life 43
To Next Page
Loading...
