JLG Ecolift50 - Preventive Maintenance and Inspection Schedule

SECTION 2 - GENERAL SERVICE INFORMATION
2-2 – JLG Lift – 3121741
2.2 PREVENTIVE MAINTENANCE AND INSPECTION
SCHEDULE
(See Table 2-2.)
The preventive maintenance and inspection checks are
listed and defined in the following table. This table is
divided into two basic parts, the “AREA” to be inspected
and the “INTERVAL” at which the inspection is to take
place. Under the “AREA” portion of the table, the various
systems along with the components that make up that
system are listed. The “INTERVAL” portion of the table is
divided into five columns representing the various inspec-
tion time periods. The numbers listed within the interval
column represent the applicable inspection code for
which that component is to be checked.
The checks and services listed in this schedule are not
intended to replace any local or regional regulations that
may pertain to this type of equipment nor should the lists
be considered as all inclusive. Variances in interval times
may occur due to climate and/or conditions and depend-
ing on the location and use of the machine.
Inspection and Maintenance Codes:
1. Check for proper and secure installation.
2. Visual inspection for damage, cracks, distor
tion,
or excessive wear.
3. Check for proper adjustment.
4. Check for cracked or broken welds.
5. Operates properly.
6. Returns to neutral or "off" position when
released.
7. Clean and free of debris.
8. Interlocks function properly.
9. Check for signs of leakage.
10. Decals installed and legible.
11. Check for proper fluid level.
12. Check for chafing and proper routing.
13. Check for proper tolerances.
14. Properly lubricated.
15. Torqued to proper specification.
16. No gouges, excessive wear, or cords showing.
17. Properly inflated and seated around rim.
18. Proper and authorized components.
19. Fully charged.
20. No loose connections, corrosion, or abrasions.
21. Verify.
22. Perform.
23. Sealed properly.
24. Overrides Platform controls.
25. Replace.
Footnotes:
a. Prior to each sale, lease, or delivery.
b. In service for 3 months; or Out of service for 3
months or more; or Purchased used.
c. Annually, no later than 13 months from the date of
the prior inspection.
d. Replace every 3 years.
Table 2-1. Inspection and Maintenance
TYPE FREQUENCY
PRIMARY
RESPONSIBILITY
SERVICE
QUALIFICATION
REFERENCE
Pre-Start
Inspection
Pri or to u se ea ch day ; or
At each Operator change.
User or Operator User or Operator Operator and Safety Manual
Pre-Delivery
Inspection
Prior to each sale, lease, or
rental delivery.
Owner, Dealer, or
User
Qualified JLG Mechanic
Service and Maintenance Manual
and applicable JLG inspection form.
Frequent
Inspection
In service for 3 months; or Out of service for a
period of more than 3 months; or Purchased
used.
Owner, Dealer, or
User
Qualified JLG Mechanic
Service and Maintenance Manual
and applicable JLG inspection form.
Annual
Machine
Inspection
Annually, no later than 13 months from the
date of the prior inspection.
Owner, Dealer, or
User
JLG Factory Trained
Service Technician
(Recommended)
Service and Maintenance Manual
and applicable JLG inspection form.
Preventative
Maintenance
At intervals as specified in the Service and
Maintenance Manual.
Owner, Dealer, or
User
Qualified JLG Mechanic Service and Maintenance Manual
Go to Discount-Equipment.com to order your parts