PowerBoost DC Converter System 1.5: Quick Start Guide
16995-01 rev. D
This document contains proprietary information. No part of this document should be reproduced
or distributed beyond its intended recipients without the express written consent of JMA Wireless. 73
• It also indicates that the telemetry between Raycap top and bottom is missing or
damaged.
o Check the RS485 cable on Raycap and to the PB-COM
o Check telemetry wiring connection between Raycap base and the top
o Reset PB-COM or power cycle the Orion controller
o Check system installation for RS485 signals
• PB-COM LED green flashing at approximate one second interval indicates that it is
receiving valid data from Raycap OVP telemetry.
To Next Page
Loading...
Need help?
General