connector can be used for communication connection between inverter and
monitor equipment.
The COM terminal outside is for remote communication, output cable connect
into monitoring PC. please refer to table 6-4 for COM terminals with inverter
weak current signal connection terminals instruction.
The following diagram guides you to connect a single inverter to monitoring equipment.
Figure6-10 Diagram of single communication wiring
The wiring diagram is schematic diagram, just take HEXIN converting module
as an example. If the user choose other converter, need according to the
converter‘s instructions, wiring the inverter’s A, B wires to the converter’s
correct terminal.
Please refer to “Inverter Management System User Manual” for the
corresponding monitoring software settings, after completing the wire
connection.
To Next Page
Loading...
