Jntech JNP75KH - Parameter Setting

50
ENTER
UP/DOWN
UP/DOWN
ENTER
Pin 0W
R-Mode MPPT
Iin 0A
Vin 0V
Iaout 0A
Fout 0.00Hz
Run/Stop Stop
D_Mode Auto
OF-F On
RunInfo
InverterInfo
MotorCtrlPara
Statistic
Settings
Fault Inquiry
ESC
RunInfo
RunInfo
InverterInfo
MotorCtrlPara
Statistic
Settings
Fault Inquiry
ESC
Statistic
RunT_D 60min
RunT_T 1h
E-Day 0kWh
E-Tot 0kWh
ESC
RunT_D 60min
RunT_T 1h
E-Day 0kWh
E-Tot 0kWh
ESC
ESC
RunInfo
InverterInfo
MotorCtrlPara
Statistic
Settings
Fault Inquiry
ESC
Statistic
Figure8-9 Statistic data inquiry procedure
Table8-8 Detailed statistic data
Statistic
Explain
RunT-D
Inverter daily running duration. This figure will be reset when
recharged.
RunT-T
Accumulative running duration. This figure can be reset manually.
Please refer to “8.3.3Statistical Data Clear”.
E-Day
Daily power inverted. This figure will be reset when recharged.
E-Tot
Accumulative power inverted, can be reset manually. Please refer
to “8.3.3Statistical Data Clear”.
ESC
Return to the previous menu
8.3.5 Parameter Setting
Settings, set the parameter, please refer to the figure below.