Jntech JNP75KH - Motor Control Parameter Interface

47
LCD-Ver
Version information of LCD program.
DSP-Ver
Version information of DSP program.
SiteNum
Site number of network node of inverter, when communicate
with RS485. Default value is 10. If modifiable, please refer
to“8.3.5.4Site Number Set”.
SN
Series number of inverter.
Ty
Type of inverter.
Date
Current day, from left to right shows day, month and year.
This figure is modifiable, please refer to “8.3.5.1Display Time
Set”.
Time
Current time, modifiable, please refer to “8.3.5 Display Time
Set”.
ESC
Return to the previous menu
8.3.3 Motor control parameter interface
“Motor ctrl Para”, which is the displayed value after finishing motor detection,
and relative parameters for motor control computed by. Please refer to the
following diagram for motor control parameter query.