37
Shunting a Body
The operator of the hook-lift is responsible for handling it. Care must be taken to
avoid injury or damage. Before operating the hook-lift make sure that you have read
and are fully aware of the warnings in this manual and on the hook-lift.
To shunt a body follow the procedure listed below:
1. Make sure that there is nobody within the working area of the vehicle and the body.
2. If the vehicle has retractable axles, make
sure that they are lowered.
3. Start the hydraulic pump.
l CBW controller – the pump icon is dis-
played at the top of the screen. See
"User Interface", on page 12.
l LED display – the pump LED will illuminate. See "LED Display and Buttons", on page 20.
4. Open the hydraulic lock.
l CBW controller – the icon for open
hydraulic lock isdisplayed on the
screen. See "User Interface", on page
12.
l LED display – the indicator lamp for the
hydraulic lock lights red. See "LED Dis-
play and Buttons", on page 20.
5. Reverse the vehicle as straight and as close as possible towards the trailer. Make sure not
to damage to the trailer's tow-bar.
Hookmaster manual: 13293 Edition 6 | 2021-02-22
To Next Page
Loading...