39
Unloading a Body
The operator of the hook-lift is responsible for handling it. Care must be taken to
avoid injury or damage. Before operating the hook-lift make sure that you have read
and are fully aware of the warnings in this manual and on the hook-lift.
Read the information under "Distributing a Load on a Body", on page 29 before unloading the
body.
To unload a body, follow the procedure listed below:
1. Make sure that there is nobody within the working area of the vehicle and the body.
2. Start the hydraulic pump.
l CBW controller – the pump icon is displayed at the top of the screen. See "User Inter-
face", on page 12.
l LED display – the pump LED will illuminate. See "LED Display and Buttons", on page 20.
3. Open the hydraulic lock.
l CBW controller – the icon for open
hydraulic lock isdisplayed on the
screen. See "User Interface", on page
12.
l LED display – the indicator lamp for the
hydraulic lock lights red. See "LED Dis-
play and Buttons", on page 20.
4. Raise the tip frame and run the sledge
back.
Fast operation mode must only
be used with minimal load.
Hookmaster manual: 13293 Edition 6 | 2021-02-22
To Next Page
Loading...
Need help?
General