• Quick Start
EAZ0090G04A
• Spare Parts Manual
TEEWH512A3 - Service Manual
Manual for use by service personnel only.
• Operator’s Manual
ZEEWH512A06 (Chapter 1 – 9)
The operator must be familiar with it.
EHP System II E.
12 - EN
3.0 Introduction
Congratulations on purchasing the pneumatic-electric
tire changer:
This
tIre changer is designed for ease of operation, safe
handling of rims, reliability and speed.
With a minimum of maintenance and care your tIre
changer will provide many years of trouble-free operation.
Instructions on use, maintenance and operational
requirements of the machine are covered in this manual.
STORE THIS MANUAL IN A SAFE PLACE FOR
ANY FURTHER REFERENCE. READ THIS
MANUAL THOROUGHLY BEFORE USING THE
MACHINE.
Application.
The tire changer is intended to be used as a device for
automatically demounting, mounting and beading car
and motorcycle tIres mounted on one-piece rims with the
following speci! cations:
Maximun tIre diam.: 40” (mm 1000)
Maximum tIre width: 12” (305 mm)
This device must be used in the application for which it is
speci! cally designed.
Any other use shall be considered as improper and thus
not unreasonable.
The manufacturer shall not be considered liable
for possible damage caused by improper, wrong or
unreasonable use.
Manuals to the unit.
• On web Accessory Plan:
http://service.snapon-equipment.net/
Installation instructions.
The installation instruction are in Chapter 9 Appendices.
EC DECLARATION
(Original document contained in Spare Parts Booklet)
To Next Page
Loading...
