12 Hardware Installation—IFC-200 Hardware Installation Procedures
6. Press the Set key (third key from the left). All printer parameters list
automatically at this point.
7. At the “Technical” heading, use the left/right arrow keys to move the
print head over the “Menu” heading.
8. Press the Set key.
9. Use the left/right arrow keys to position the printer head over the
“Paper Handling” heading.
10. Press the Set key.
11. Use the left/right arrow keys to move the print head under the “3s”
selection.
12. Press the Set key.
13. Press Local.
Note: Current shipments of the PRN-3 have been modified to include this
software selection.
The IFC-200 may also be used with a Keltron printer. For more
information, or to order a Keltron printer, contact Keltron Corporation at
the following address:
Keltron Corporation
225 Crescent Street
Waltham, MA 02154
617-894-8700
Figure 7: CRT-1 Connections
Keltron Printer
Option
CRT-1
Configuration
T
B
4
T
B
5
T
B
6
Connect CRT-1 pin 3 to TB4 TX
Connect CRT-1 pin 7 to TB4 REF
Connect CRT-1 pin 2 to TB4 RX
Plug this DB-25 connector
into the RS-232 port of the CRT-1.
CRT-1A
IFC-200
System Common (-)
IFC-200, TB1-2, or
Enclosure
CRT-1
7321
TX REF RX REF
OUT OUT IN IN
A B B+- A+- B- A-
To Next Page
Loading...
