Console Engineering Mode Guide JET-7000 (Old)
III.
To calibrate the
speed.
IV. (Old Version)
To choose
metric or
British
mode.
(New Version)
To choose
metric or
British mode.
(Except the ver 0.3)
u If the distance between the front bottom edge of the
frame and the floor does not meet the specifications
either at the maximum or minimum incline, you have
to adjust the location of the related limit switch to
calibrate the incline to Spec.
1. Press Slow, Down, and RESET keys
simultaneously.
2. While the display reads "CAL-HI", press Up
key. Then the display shows "SLO".
3. Read the real speed from the window of "TIME". (The
speed value on the "TIME" window is in British
System only)
4. Using the Fast or Slow keys to adjust the speed of the
treadmill to 0.5mph (0.8kph). Then press
START/STOP key, and the display shows "FAS".
5. Using the Fast or Slow keys to adjust the speed of the
treadmill to 12.4mph (20.0kph).
6. Press to START /STOP key to store.
(OLD): Hold down SAFETY and POWER keys, then
remove SAFETY key then the display shows "Si" or "bri".
u If you want the metric mode, you must remove
POWER key when the display shows "Si".(the British
mode ê "bri") Then the display shows "bye" briefly,
and reset itself.
(NEW): Hold down SAFETY, PROGRAM
INTERVAL and RESET keys, then remove SAFETY
key then the display shows "Si" or "bri".
u If you want the metric mode, you must remove
PROGRAM INTERVAL and RESET keys when the
display shows "Si".(the British mode ê "bri") Then
the display shows "bye" briefly, and reset itself.
4-1 Revision: 1.0 Date: 2001-06-01
To Next Page
Loading...
Need help?
General
