DJUSTING NUT #2
C. Passengers
The vehicle allows for two riders
only. Combine maximum weight of
driver and the passenger should not
exceed 180kg (400Ibs).
D. Seat Adjustment
The seat must always be securely
fastened in the position which best
affords the operator control of the foot
pedals, steering wheel, and the
remote stop button.
a. Pull seat adjustment handle
upward to disengage seat slide.
b. Move seat to desired position.
c. Be sure seat adjustment handle
snaps back into place and that
seat is locked into position.
Before attempting to adjust the seat ensure that engine of the Go-Kart is stopped.
Never operate this Go-Kart when the provided seat is not securely fastened, to do so
could result in a strong possibility of severe personal injury or loss of life. Before attempting
to adjust the seat ensure that engine of Go-Kart is stopped.
E. Shift Adjustment
a. Press down the shift lever to the “L”
position so that the unit can move
forward at low speed, press the lever to
“H” position so that the unit can move
forward at high speed, Pull back the shift
to “N” position so that the unit can’t move,
pull back the lever to “R” so that the unit
can move backward. (See Fig. 6)
b. Loosen lock nut, and remove the cotter
pin and the plain washer. Rotate the
joint, the shifter lever will rotate
clockwise or counter clockwise, so you
can adjust the lever in proper position
LOCK NUT
Figure 6
Seat adjustment handle
JOINT
Figure 5
To Next Page
Loading...
