4. Installation, Setup and Check
JCY-1800/1850 VDR/S-VDR Maintenance Software Instruction Manual
14
DOC No. 7ZPNA4014
4.3.3. Selecting a recording data
Select the connection equipment and recording data according to the following procedure.
The initial value for receiving the data of the equipment chosen is set up automatically on the detail setting window.
4.3.3.1. In the case of new setting
Select a “recording item” from the pull-down menu.
Click the [Next] button.
Select connected “equipment” from the pull-down menu.
Select the “Other”, when there is no appropriate item which should be set up
Enter an appropriate data for connected equipment on a "Data" tab screen.
Caution) In case of a recording data item to set up is not displayed:
Object data are registered into other channels. It is necessary to clear a setup of CH registered.
Setting data are not cleared by connection disable. Refer to the following procedure for deleting setup data.
To Next Page
Loading...
