4. Installation, Setup and Check
JCY-1800/1850 VDR/S-VDR Maintenance Software Instruction Manual
15
DOC No. 7ZPNA4014
4.3.3.2. When setting data is changed
• In case of changing the detail setup data registered:
Choose the “No” (Default) of radio button and click the [Next] button.
• In case of changing the selected “Recording item” and selected “Equipment”:
Choose the “Yes” of radio button and click the [Next] button.
4.3.3.3. When registered setup data are deleted
Enter the check mark into the check box of lower "delete information", and click the [Next] button.
A registered setup data is deleted.
In the following cases, it is required to delete the setting data of CH which are not connected.
Example) a shipment setup is a default setting for recording a heading data from CH4 by NMEA.
Since the heading data is outputted with the step signal, it should be connected to CH33 (NSK).
1) Setup error
If a setup data remains even if it removes a check mark from a check box of the CH4, a following error
dialog will be displayed at checking mark to the CH33.
2) Setup procedure
Delete the setup data of the CH4 according to upper procedure.
Enter the check mark into the check box of CH33.
Enter setup data for receiving the heading data into detail window of CH33.
To Next Page
Loading...
