6-23
i.e. step back on the same menu level.
Menu button and Enter buttons pressed simultaneously will move up one menu level,
except when leaving the “Remote Device menu”. (see Esc-button)
Enter: “4th button from left” is used to store changed values or to move to sub-menus.
- + “Minus button” and “Plus button” are used to change values or status (E.g. write
access OFF/ON) and /or to change device values.
Note: The Menu System will exit automatically if no button has been pressed for 5 minutes
when being in the local SD4 Menu System, when connected to a remote device there is no
timeout and the Escape button must be used to exit from a remotely connected device.
5.1.2 Main Display in Menu Mode
The Menu Mode in the Main Display has three “Local Menus” and one “Remote Device menu”:
x SD4 LOCAL. This is the start menu when entering the Menu Mode. If one or more
other displays are remotely dimmed from the display, this menu shows a second text
line were the remote dimming function can easily be turned ON/OFF.
x LP0 PROPERTIES. This menu contains sub menus for local setting up of the display.
Note: Do not turn write access ON without special training.
x LS0 REMOTE SETUP. This menu contains sub menus for setting up when the display
is used as a Speed log Master Display /Remote Device for other units and displays.
Note: Do not turn write access ON without special training
x R0 REMOTE DEV. On designated Speed Log Master Displays this menu provides
access to a remote device, e.g. the WTU-unit, BTU-unit or the Sig. Distributor menu
structure.
Note: Verify that the setting in SD4 menu LS7 is “R0 REMOTE ENABLED [ON]”
to be able to connect to remote devices.
To connect to the menu system in the Sig. Distributor:
When in SD4 LOCAL (the start menu) step to R0 REMOTE DEV menu by pressing the
MENU button three times.
When pressing ENTER in the R0 menu the Main Display will establish communication with all
connected equipment and display them in a list of menu choices.
Press the MENU button until the LPU is displayed and press ENTER to start communicating
with the Sig. Distributor.
ESC is used to step back.
To Next Page
Loading...